The boilers are constructed for burning wood on the principle of gasifying with the use of a  exhaust gas ventilator, which draws the combustion gases from the boiler, or leads air into the boiler. The boiler body is welded from 3-8 mm steel sheets. They comprise the fuel hopper, which is equipped at the bottom with a heatproof pipe fitting with longitudinal hole for the combustion gases and passage of gases. The burnout part of the multiple chamber furnace under the fuel hopper is equipped with ceramic pipe fittings. There is a vertical combustion gas duct in the back of the boiler body, which is equipped with a heating valve in the upper section. The upper part of the combustion gas duct is fitted with a gas exhaust outlet for connection to a chimney.

ADVANTAGES OF ATMOS GASIFICATION BOILERS FOR WOOD

• Option to burn large pieces of wood
• Primary and secondary air is also preheated to a high temperature - higher effectiveness
• The ventilator automatically switches off when the fuel burns out.
• Easy servicing and cleaning
• Ceramic combustion space - high effectiveness
• Large fuel container
• Large space for ash (we clear it out once a week with wood)
• Boiler without tube plate - easier cleaning
• Small size and low weight
• High quality

Reverse combustion and a ceramic combustion chamber enable perfect combustion with minimum polluting emissions. The boilers comply with environmentally-friendly product requirements according to Guideline No. 13/2002 of the Czech Ministry of Environment.

INSTALLATION

ATMOS boilers must be connected via the LADDOMAT 21 or ESBE thermoregulation valve to achieve keeping the minimum temperature of water returning to boiler at 65°C. The temperature of water exiting the boiler must be permanently kept between 80 - 90°C. The default configuration of all boilers includes a cooling circuit to prevent overheating. We recommend installing boilers with accumulation tanks.

CERTIFICATION

All ATMOS boilers are certified in testing laboratories for the individual countries of destination: State Testing Laboratory Brno, TÜV Munich - Germany,  according to current standards - EN 303-5.
Protected by patent.

Electrical - mechanical - Power is controlled with a safety valve operated with the draught regulator, FR 124 type, which automatically opens or closes the safety valve according to a set output temperature of water (80 - 90°C), (except for DC50SE) instead of this, the boiler is equipped with a BELIMO servo flap with a spring. When setting the power regulator, much attention should be paid because the regulator has another important function other than power regulation - it also secures the boiler against overheating. A controlling thermostat located on the boiler panel regulates the fan according to a set temperature (75 - 85°C). A temperature lower by 5°C should be set on the controlling thermostat rather than on the FR 124 draught regulator.
The boiler runs at a reduced output even without a fan - heating is not lost when the electric power fails. At up to 70 percent of its rated output, the boiler can be operated without a ventilator.